Last updated: Friday 29th March, 2024

Gate nano hard mosfet

£4999

Out of stock

Email when stock available

Secure your item now
Pay 20% deposit now and pay balance within 30 days
You are welcome to spread your payments so pay a bit at a time / or in full, its up to you
Please Note: Your item will not be dispatched until payment has been received in full.
Please read our full terms and conditions for further details.
Categories: , , Product ID: 95721

Description

Gate Nano HARD Mosfet

Gate Nano HARD Mosfet

About the Gate Nano HARD Mosfet.

Gate Nano HARD Mosfet is a multifunctional programmable AEG Controller. It has 8 functions. Thanks to its special coating, it is resistant to atmospheric conditions (Military Specification MIL-V-173C). Battery protection supports: Li-Po 7.4V / 11.1V / 14.8V. You can also disable the protection and use other batteries.

About the Gate Nano HARD Mosfet.

MOSFET transmits the energy from the battery directly to the motor, bypassing the traditional mechanical trigger contacts. As a result, the replica gains a higher rate of fire, faster trigger response, and the contacts are protected against burn out.
ACTIVE BRAKE in SEMI Mode does not allow for compressing a piston after a shot. The piston will stop in the front position which eliminates unnecessary stresses, increasing the service life of the gearbox and its parts. This is important, especially in AEG power upgrade.

ON/OFF ACTIVE BRAKE The Controller provides the option to decide if you want to use the Active Brake function. If you do not need this, you can turn it off easily. It will lead to improving the lifespan of your motor.

SMART FUSE – the unit has thermal protection for increased durability and in combination with a time-lag fuse, it fully protects your AEG installation.

DEBOUNCING – provides full compatibility with micro-switches. It ensures complete resistance to contact bounce and thanks to it the replica gain a bigger ROF, a faster trigger response and the MOSFET is less prone to overheating.

BUILT-IN SELF-TEST This allows you to quickly check whether the device is working properly. It helps to locate where the problem lies when anything goes wrong.

BATTERY PROTECTION – against Over-Discharge of the Battery. The microprocessor monitors the battery voltage constantly. When the voltage drops down to a critical level, the Controller will not allow firing.

COATING Thanks to its special conformal coating, our product is resistant to atmospheric conditions (Military Specification MIL-V-173C).

BUILT-IN SELF-TEST- It allows to quickly check whether the AEG Controller works properly. If there is a problem with your AEG, the BUILT-IN SELF-TEST allows you to check that the problem is not caused by the Controller.

Included in the Gate Nano HARD Mosfet kit:
NanoHARD
Additional kit of Deans-T Connectors
Single signal wire for trigger contacts
Double signal wire for trigger contacts
Programming button Jumper (2pcs.)

Warning: GATE does not guarantee the compatibility of mosfets and ETUs such as TITAN or ASTER with brushless motors. Connection of a brushless motor can cause immediate damage to the device, motor and battery, that is not covered by the warranty and can lead to a fire.

 

Last updated on March 3rd, 2024 at 08:34 am